WEEK 10 - Construct The Circuit

• After got all the components and equipment, this week I will start to construct the circuit.
• With a help from some friend, will make me an easy doing progress of making circuit.
• Starting with constructing the 'Inverter Circuit'.
• Then continue with 'Charging Controller Circuit'
• For this week, we do more focus on making Inverter Circuit, because its more complicated.
• Maybe for the Charging Controller Circuit will be done on next week.

FYP 2 Students,

Azri Sabri

WEEK 9 - Purchased Components (Electrical's Part)

• After done listing all the components needed, this week I decided went to Jalan Pasar again for searching and buying the components.
• Lucky me because all the components that been listed:

1. relay
2. rechargeable battery
3. toogle switch
4. transformer
5. LED
6. capacitor
7. resistor
8. voltage regulator
9. 555 timer
10. transistor
11. preset resistor
12. PCB board
13. ect....

          are founded and available at Jalan Pasar and easy for me to purchase.

FYP 2 Students,

Azri Sabri

WEEK 8 - Research On Components (Electrical's Part)

• After been doing research on the circuit that want to use for this project on last week, i had listed the component that needed for construct the circuit.
• The circuit needed for this Mini Hydroelectric Generator is the 'Inverter Circuit', 'Charging Controller Circuit' and 1 unit transformer.

Charging Controller Circuit

Inverter Circuit

• The components been listed and needed base on figure of circuit above:

1. relay
2. rechargeable battery
3. toogle switch
4. transformer
5. LED
6. capacitor
7. resistor
8. voltage regulator
9. 555 timer
10. transistor
11. preset resistor
12. ect....

FYP2 Students,

Azri Sabri

WEEK 7 - Research On The Circuit

• After done about 60% progression of mechanical's part, I think I should do more focus on my electrical's part.
• Starting with do some research on the circuit that been needed for making an electrical's part.
• From my research, to operate my project starting water flow for rotating turbine, then to the output 240V, it need 3 stage of circuit. 
• 1st stage, from turbine, it will generate the motor to produce 12V of DC current, to charging the battery. At that stage, the circuit needed is 'Charging Controller Circuit'.
• 2nd stage, from the 12V DC current output of battery, it need to convert to AC current. This stage, the 'Inverter Circuit' needed to convert DC-AC.
• 3rd stage is about to increase the value of AC current to be an output of 240V. So it need the transformers.

FYP 2 Students,

Azri Sabri