WEEK 15-18 - Making Final Report And Submitted

• After done the presentation day, now all FYP students must completing their Final Report and submitted before week 18 of S1'2013 (23 MAY 2013)

Hard Covered Final Report

• The submitted of this Hard Covered Final Report to the Resource Centre are mean that end of FINAL YEAR PROJECT!
  
  ALHAMDULILLAH...  =) Now I can focus on doing revision for my final exam S1'2013

FYP2 Students,

Azri Sabri

WEEK 14 - Preparation And Presentation

• Design the poster for Presentation Day.

• Do some preparation for FYP presentation day.
• Finally in this week, student should present all of work done to judges. The objective is to show what are student had learn around 1 year doing research of project.
• Alhamdulillah! thanks to god, my project and presentation successfully done =)

FYP 2 Students,

Azri Sabri

WEEK 13 - Combined Mechanical And Electrical's Part.

• After been a couple of week I had construct the circuit, now in this week, I combined together all both part, Mechanical and Electrical.
• After attached the electrical's part to the mechanical's part, I doing 1st running, and it successfully.

FYP 2 Students,

Azri Sabri

WEEK 12 - Making Motor

• At the first, I planned to build the motor for generate an output 12V DC by myself.
• By using copper coil and perspex, I start the progress of making the motor.

• But, unfortunately we failed! Because after test running and do some troubleshoot, the output of ampere from this motor is to low and not compatible for charging the battery.
• So, I decided to exchange this motor to car alternator. 

WEEK 11 - Continue Construct And Combine The Circuits

• Like I said last week, we probably cannot be done constructing for the second circuit.
• Its not a big deal, we continued in this week.
• And finally we done at last.
• After done making both circuit, we combined it together with transformer that we had buy on week 9.

Here I give a simple explanation about my circuit. For making Mini Hydroelectric Generator operate properly, it need 2 circuits that is a 'Charging Controller' and 'Inverter', then need 1 unit transformers.

• Charging Controller Circuit = to stabilize an output 12v DC current from motor and charge the battery for the power storage.
• Inverter Circuit = to convert the DC to AC
• Transformer = to increase the level of current voltage (it need for making an output of 240V from plug)

FYP 2 Students,

Azri Sabri

WEEK 10 - Construct The Circuit

• After got all the components and equipment, this week I will start to construct the circuit.
• With a help from some friend, will make me an easy doing progress of making circuit.
• Starting with constructing the 'Inverter Circuit'.
• Then continue with 'Charging Controller Circuit'
• For this week, we do more focus on making Inverter Circuit, because its more complicated.
• Maybe for the Charging Controller Circuit will be done on next week.

FYP 2 Students,

Azri Sabri

WEEK 9 - Purchased Components (Electrical's Part)

• After done listing all the components needed, this week I decided went to Jalan Pasar again for searching and buying the components.
• Lucky me because all the components that been listed:

1. relay
2. rechargeable battery
3. toogle switch
4. transformer
5. LED
6. capacitor
7. resistor
8. voltage regulator
9. 555 timer
10. transistor
11. preset resistor
12. PCB board
13. ect....

          are founded and available at Jalan Pasar and easy for me to purchase.

FYP 2 Students,

Azri Sabri